35823-1-0220
Page 1
Empire Comfort Systems Inc. • Belleville, IL
3. Disconnect the wire harness at the connections shown
in
Figure 2.
DISCONNECT HERE
TO INSTALL LIGHT.
Figure 2
4. Insert the light socket wires through the rectangular
hole in the firebox roof which was uncovered in step 2.
Hold the light housing so that the socket is on the right
and feed the light socket wires to your right and down
the side of the firebox as shown in
Figure 3 on Page 2.
5. Fit the light housing in place in the firebox roof and
reconnect the light socket wires to the rheostat and
receptacle terminals as shown in
Figures 2 and 3.
6. Choose either the orange or clear glass for your
light. Screw the light housing into the firebox roof,
sandwiching the gasket, glass, bezel, and light shields
together in the order shown in
Figure 4 on page 2.
TOOLS NEEDED:
•
Phillips Screwdriver
CARTON CONTENTS:
•
Light Assembly
•
4 - #10 X 1/2" Screws
•
Bezel
•
Glass (2)
• Gasket
•
Halogen Light Bulb
•
Light Shield (2)
INSTALLATION
1. Working from the side of the fireplace which puts the
vent on your right, remove the glass frame and screen
frame as a unit (see fireplace installation instructions)
as well as the lower access panel.
2. Remove the four screws which secure the metal plate
and gasket from the firebox roof.
See Figure 1.
Figure 1
FOR USE ON MODELS: DVCP36(SP,PP)
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION
INSTALLATION INSTRUCTIONS
LK7-1 LIGHT KIT
