10
www.empirecomfort.com
Fireplace Installation
For 240V Installations
Use three conductor, non-metallic
sheath cable with ground wire
(4 wires total) for the incoming
power supply on fireplace inserts.
CAUTION:
Use the appropri-
ate wire to meet local and
national electrical codes for
rated power consumption.
•
Connect the L1 wire from the
unit to the L1 wire from the
power supply.
•
Connect the L2 wire from the
unit to the L2 wire from the
power supply.
•
Connect the N wire from the
unit to the neutral wire from
the power supply.
•
Connect the H1 and H2 wires
together, with a wire connec
-
tor and leave them discon
-
nected from everything.
•
Attach the grounding wire to
the cover with the provided
grounding screw. Place wire
in-between screw and lock
washer and tighten (Figure 4).
•
Reposition the electrical cover
brackets over the wires and
connectors and attach to fire
-
place chassis using the screw
removed in step 1 and step 3.
Surface Mount Installation
CAUTION:
Two people will be
required for various steps of
this procedure.
WARNING:
Ensure that the
circuit on which the fireplace is
to be installed has the power
cut off at the service panel
until installation is complete.
1. Determine the mounting
location of the unit so that the
wall-mounting bracket can be
installed into 3 wall studs.
!
NOTE:
It is recommended
that the mounting bracket be
installed 56 in. (142 cm) off
of the ground to maintain an
optimized viewing angle of the
flame.
2. Hold the wall mounting brack
-
et, with the bubble level on
the top, on the wall so that the
bubble on the level is centered
between the two black lines.
3. Mark the 4 mounting screw
locations, on the wall, ensur
-
ing that the wall bracket stays
level. (Figure 5)
4. In locations where the screws
are being installed only into
drywall, install the supplied
wall anchors before installing
