Emotron EMX-D, Instruction Manual

Page: 38 / 53

Emotron AB 01-5016-01r0 Functional Description 31
Warning [722]
Display the actual or last warning condition. A warning
occurs if the VSD is close to a trip condition but still in
operation. During a warning condition the red trip LED
will start to blink as long as the warning is active.
The active warning message is displayed in menu [722].
If no warning is active the message “No Error” is displayed.
You can find a list of all warnings in Table 9, page 35.
Digital Input Status [723]
Indicates the status of the digital inputs. See Fig. 29.
1 DigIn 1
2 DigIn 2
4 DigIn 4
5 DigIn 5
6 DigIn 6
7 DigIn 7
The positions one to eight (read from left to right) indicate
the status of the associated input:
1 High
0 Low
The example in Fig. 29 indicates that DigIn 1,
DigIn 3 and DigIn 6 are active at this moment.
Fig. 29 Digital input status example
Digital Output Status [724]
Indicates the status of the digital outputs and relays. See Fig.
30.
RE indicate the status of the relays on position:
1 Relay1
2 Relay2
3 Relay3
DO indicate the status of the digital outputs on position:
1 DigOut1
2 DigOut2
The status of the associated output is shown.
1 High
0 Low
The example in Fig. 30 indicates that DigOut1 is active and
Digital Out 2
is not active. Relay 1 is active, relay 2 and 3
are not active.
Fig. 30 Digital output status example
Analogue Input Status 1 - 2 [725]
Indicates status of the analogue inputs 1-2.
Fig. 31 Analogue input status 1-2
So the example in Fig. 31 indicates that the Analogue input1
is active.
Analogue Input Status 3-4 [726]
Indicates status of the analogue inputs 3-4. These inputs are
normally not used.
Fig. 32 Analogue input status 3-4
Analogue Output Status 1-2 [727]
Indicates status of the analogue outputs Fig. 33. E.g. if 0-20
mA output is used, the value 20% equals to 4 mA.
Fig. 33 Analogue output status 1
722 Warnings
Stp warn.msg
723 DigIn Status
Stp 1010
010
NOTE: The shown percentages are absolute values
based on the full range/scale of the in- our output; so
related to either 0–10 V or 0–20 mA.
NOTE: The shown percentages are absolute values
based on the full range/scale of the in- our output; so
related to either 0–10 V or 0–20 mA.
724 DigOutStatus
Stp RE 100 DO 10
725 AnIn 1 2
Stp 65% 0%
726 AnIn 3 4
Stp 0% 0%
727 AnOut 1 2
Stp 20% 0%