Page 14
XSP-1
18. Subwoofer Outputs
Connect these outputs to the input of your powered subwoofer(s) or to the input of the
power amplifier that runs your subwoofer. Both balanced and unbalanced outputs carry the
same signal.
If you use a single subwoofer, use the Subwoofer Summed Output; if you use two
subwoofers in stereo, then use the Subwoofer Left and Right Outputs.
When the Low Pass Selector Switch is set to Full Range, these outputs will carry a full
range audio signal; when the switch is set to Low Pass, they will carry only the range of
audio frequencies below the crossover point set by the Low Pass Crossover Frequency
adjustment. Both balanced and unbalanced outputs are active at all times.
When the HT Bypass (Home Theater Bypass) mode is enabled, all three of the Subwoofer
Outputs carry buffered copies of the signal received at the Home Theater Sub Input (the
signal is reduced by 3 dB on the Left and Right Outputs).
19. AC Power Switch
Switches the main AC power to the XSP-1 On and Off. When this switch is Off, no controls
operate (the XSP-1 cannot be turned On from the front panel or remote control).
20. IEC Power Cord Receptacle
Accepts a standard IEC power cable. If you choose to substitute another AC power cable,
either a two-wire or three-wire cable may be used.
