7
TWEETER ADJUSTMENTS
The tweeter level switch allows subtle balance adjustments to accommodate room
acoustics and personal preference.
To enhance imaging the tweeter can be angled to the listening area. Pressing on the
plastic edges of the tweeter allows for 0-30
°
tilt in all directions. Be careful not to press
on the tweeter dome itself as damage will result. This will void the warranty!
SPEAKER INSTALLATION
Once you have made a decision on where to install your speakers and have verified
that the location is safe, you will need the following tools to complete the installation
• Stud Finder • Drill & Drill Bits • Wire Cutter/Strippers • Speaker Wire
• Pencil • Phillips Screwdriver • Utility Knife or Drywall Saw • Painters Tape
Use only multi stranded, copper, 16 gauge minimum, speaker wire approved for use
within walls. Consult with your local building department for approved wire types and
wiring methods.
Find a location between two wall or ceiling studs that will accommodate speaker
installation. Carefully measure for clearance and lightly trace the included cut-out
template onto the surface. Cut a small test hole near the center of your cut-out trace.
CAUTION: Proceed with the final cut out of your opening only after you have verified
your cut-out location is free from electrical wiring, water pipes, heating ducts,
obstructions, etc. THIS IS A CRITICAL STEP AND SHOULD NOT BE IGNORED!
Summary of Contents for VAC
Page 1: ...1 ...