Page 10
Stealth SP-1 Input Selector and Phono Preamp
Stealth SP-1 (Remote Control)
The Stealth SP-1 can be used with its own
compact IR remote control, or it can be controlled
by the remote control that is included with the
Stealth DC-1. The following section describes the
included SP-1 compact remote control.
Note: You must remove the insulator tab
from the batteries in the Stealth SP-1
remote control before using it for the first
time. (See the Hardware Configuration
section for details.)
1. Standby button
The Standby button toggles the power on the
SP-1 On and Off.
Note: The Stealth SP-1 will not respond to
the Standby button on the remote control
unless the rear panel Power switch is first
turned On.
2. Input Selector buttons
Press one of these buttons to select an input,
which is then routed to the output. When an
input is selected, the halo ring around the button
for the selected input on the front of the SP-1 will
illuminate.
Input 1 through Input 3 are entirely passive line
level analog inputs switched by precision relays,
and so add virtually no noise or distortion to the
signal. The Phono button selects the SP-1’s high
performance internal phono preamp.
Note: The four sides of the control ring are
buttons, and you press them to select the
Input. The ring does not rotate or tilt.
3. Vol + and Vol - buttons (used only with DC-1)
The Vol+ and Vol- have no function on the SP-1 itself. If you are using your Stealth
SP-1 with a Stealth DC-1, these buttons will operate the Volume Control on your DC-1.
VOL-
VOL+
INPUT 1
INPUT 2
INPUT 3
PHONO
