Emotiva BasX A-800, User Manual

Page: 21 / 28

Page 17
B
AS
X A-800 Multi-Zone Power Amplifier
Problem: The halo around the Standby Button and the Status LEDs are lit blue but
you are not hearing any audio.
Reason: Your BasX A-800 amp is On, so either your BasX A-800 is not receiving an audio signal or
your speakers are disconnected.
• Check your source.
• If you are using some sort of speaker switch verify that you have the correct speakers and
amplifier channels selected, and that the output is not muted.
• Check your speakers and speaker cables.
• If you are using the Bus Input, then confirm that the Bus Switch is in the Bus position.
If you are using the Zone Input, then confirm that the Bus Switch is NOT in the Bus position.
• Check that the Power Mode switch is in the correct position.
• If you’re using the Bus Input, check that the Bus switch for each Zone is in the correct position.
Problem: The halo around the Standby button and the Status LEDs are lit blue, and
you are hearing audio, but the audio sounds odd or “phasey”.
Reason: You probably have the Bridge Switch set to the Bridged position even though you’re
using individual speakers. This will cause the two speakers in that Zone to receive the same audio
signal, but out of phase.
• Confirm that the bridge Switch for each Zone is set to the correct position.