5
GB | LED Floodlight SMD + PIR SENSOR
LED reflector is designed for indoor and outdoor use to be mounted on a firm ground.
Ingress Protection IP54 – for outdoor use
PIR sensor – specification:
Time-delay: min. 10 s ±5 s – max. 10 min ±1 min
Detection angle: 120°
Ambient light: 5 lux –> 2 000 lux (adjustable)
Detection distance: 5–10 m
Detection motion speed: 0.6–1.5 m/s
PIR sensor setting:
Detection field is possible to be set by moving the motion sensor switch to the left and to the right.
Adjustment of the ambient light (sensitivity)
You can choose at what luminosity will the sensor go on by a button A (see picture no. 4).
Time-delay
You can set the time-delay of the lamp by a button B (see picture no. 4)
Detection range
The distance at which the sensor responds to movement can be set using the control C.
Mounting
Mount the lamp firmly onto a solid basis, for example a wall (fig. 1, 2, 3).
Installation height 2.3–3 m.
Direct the reflector as shown on fig. 1 and 2.
Connect a 220–240 V~ power cable to the respective terminals of the terminal strip.
N – blue – neutral wire
G – green&yellow – earth wire (ground)
L – brown – live wire
Maintenance instructions:
Before maintenance, switch off the lamp and wait until it is cooled.
Clean it with a soft moistened cloth.
Never submerge the lamp in water or other liquids.
During maintenance, observe general rules for occupational safety, and be very careful.
WARNING
• The reflector is designed entirely for firm mounting.
• Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be
carried out only by an authorized person.
• Respect a minimum distance of 1 m between the appliance and the object or surface which you wish to lighten.
• If you place the reflector below the roof, keep the minimum 0.2 m distance measured from the upside of the reflector
to the bottom of the roof.
• Do not use the reflector without the protection glass.
• The protection from dangerous contact voltage is ensured by „earthing“.
• No cord supplied with floodlight
• The lights source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire
shall be replaced.
• Caution, risk of electric shock
.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for in-
formation about collection points. If the electronic devices would be disposed on landfi ll, dangerous substanoes may
reach groundwater and subsequently food chain, where it could affect human health.
EMOS spol s r.o. declares that the LED Floodlight SMD + PIR SENSOR is in compliance with the essential requirements and
other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be
found at http://www.emos.eu/download.
