3
GB
Rechargeable LED lantern
1
2
3
4
1 – switch;
2 – LED spotlight
3 – micro USB port;
4 – USB outlet 5 V DC/1 A
Specifications
Rechargeable lantern with Li-Ion accumulator, resistant to rough conditions (dust, dirt) for household use. 10 W CREE LED
ensures sufficiently high luminous intensity. The lantern can be charged, or recharged, from a 230 V~, 50 Hz network or from
a 12–24 V DC car socket. If the lamp accumulator is depleted, the lantern can still be used by connecting the enclosed power
adapter or car adapter. Connecting the USB cable to a USB port allows charging the batteries of portable devices with USB
charging parameters (5 V DC/1 A) e.g. smartphone = power bank function.
Specifications:
Power supply: Li-Ion 18650 accumulator;
3.7 V DC / 4 000 mAh
Source of light: 10 W CREE LED – up to 850 lm
Light modes: 50 %, 100 %, flashing, off
Range: 222 m (100 %), 110 m (50 %)
Light duration: 3 h (100 %), 8 h (50 %), 5 h – flashing
Charge time: 12 h
Protection against accumulator overcharge LED indicators:
charging – red, charged – green
Lantern operating temperature: – 5 °C to +35 °C
Lantern charging temperature: +5 °C to +35 °C
Lantern size: 150 × 220 × 160 mm
Lantern weight: 640 g (l AC/DC power
a car adapter)
Charging:
Charge the lantern‘s accumulator before first use. Use the enclosed AC/DC adapter or car adapter. Charging a fully depleted
accumulator takes 12 hours.
Charge the lantern in dry indoor areas at a temperature of +5 °C to +35 °C. If the lantern is
not used for an extended period of time, it is necessary to recharge the accumulator before further use. The accumula-
tor self-discharges and must be recharged at least once every 3 months to prevent its voltage from dropping and the
accumulator potentially being rendered unusable.
1. Connect one end of the USB cable (USB-A) into a USB port of adapter S050-050-EU and the other end‘s micro USB to the
input port in the lamp; then connect the adapter to a 230 V~/50 Hz power network. A red indicator will turn on on the
lamp. When the lantern (accumulator) is fully recharged, a green LED will light up.
2. After recharging, disconnect the adapter from the lantern after 12 hours at the latest. The accumulator can be recharged
intermittently – it has no memory effect.
3. The lantern can also be recharged in the car – 12–24 V DC through the lighter socket. Procedure for plugging in and
recharging is similar as when using a network adapter. After recharging, disconnect the car adapter.
The lantern can be recharged using a car adapter only when the vehicle is stationary and the engine is turned off. Do
not under any circumstances charge the lantern when the car engine is running or the car is in motion.
Changing the accumulator:
The accumulator must only be changed by a person with appropriate training in electrical engineering.
Remove the accumulator pack and replace with a new one with same dimensions and electrical parameters. The new
accumulator must be purchased only from the manufacturer. Never use non-original components. Makesure to observe
the correct polarity when changing the accumulator.
