4.8 Entering to the Programming Mode, Changing and Saving Parameters
When Set/OK is pressed for 5
sec. “P” led starts flashing. If
Programming Mode accessing
password is defined, then
Program Mode Entering
screen
is shown on the
screen.
Main Operation Screen
Division Rate Parameter
Programming Screen
Division Rate Parameter
Value
Programming Screen
Programming Mode
Entering Screen
Press Increment
button for accessing
to Password
Entering Screen
Password Entering Screen
Enter Programming mode accessing password
with Increment and decrement buttons.
Confirm the password with
using the Set/OK button.
Note-1:
If
Programming Mode
Access password is 0,
then Programming
mode entering screen
is not seen.
Division rate
parameter is seen
27
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
SET
P
OP
SIG
SV
Password Entering Screen
Note-2:
Parameters can be observed by pressing SET/OK button in password entering
screen without entering the programming mode entering password. But parameters can
not be changed.
Press increment button for accessing to the
parameter value. Press Set/OK button for
accessing to the next parameter.
Change the value with increment
and decrement buttons.
Division Rate Parameter
Value
Press Set/OK button for
saving the parameter.
Division Rate Parameter
Press Set/OK button for
accessing to the next parameter.
i
If no operation is performed in Programming mode for 20 seconds, device turns to
main operation screen automatically.
