15
EM-210DVI/410DVI
FCC CERTIFICATIONS
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with
emission limits.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
EM-210DVI/410DVI
Note:
The interval between these two keys should be no more than 0.5
seconds. Once scanning begins, it continues until you press
any key
to
exit AutoScan Mode.
Flash-Upgrade
With internet flash-upgrade capability you can update your KVM Switch with the
latest firmware upgrades via a parallel connection. Please visit
www.emine.com.tw
for upgrade information and support.
To update the firmware, you will need the following items
1. A separate computer running Windows 95, 98, ME, 2000 or XP. This
computer must not be connected to the CPU ports on your KVM switch.
2. An available parallel port on the computer.
3. A custom flash cable. (Mini USB B-type to USB A-type)
© 2003 Emine Technology. All rights reserved. The
ExsorView
series is a trade mark of Emine. All
trade names are registered trademarks of their respective owners.
