3
5.
Install start assist capacitor(s).
START ASSIST KIT INSTRUCTIONS
S2C Shown
First of 2 capacitors installed
S2C Before
Note:
The S2C, will need 2 kits,
separate start assist capacitor
for each of the 2 compressors.
Fasten clip onto the
capacitor
Note:
Number of compressors determine the number
of kits needed. Separate start assist capacitor must be
installed on each of the units’ compressors.
For Side Discharge (S1C & S2C) units
the wiring diagram is on the inside of
the left side service panel.
Remove the 4 screws on the left panel
and lift off.
Note:
The T4C, will need 4 kits, a separate start assist
capacitor for each of the 4 compressors.
T4C Shown
T4C with 4 capacitors installed
T4C Before
For Top Discharge (T2C,T3C & T4C) units
the wiring diagram is on the inside of the
front service panel.
6.
Secure the start assist capacitor(s)
in such a way that it will not be
damaged by moving or hot parts
(see photos opposite page).
7.
Replace all access panels.
8.
Turn on power supply.
9.
Check unit for proper operation.
