NOTE REVERSED CONNECTOR
VOLUME
B122rH
VOLUME
B122rH
TONE
B124rH
Diagram #1
Like all EMG Accessory products, the SPC and RPC use a 5-pin connector.
Diagram #1 to the right shows how the plug-in connectors are installed.
Be sure to reverse the input connector as shown.
Since there are a variety of installations in which the SPC or RPC can be installed it
is impossible to show every installation in this data sheet. Some of the simpler
installations have been chosen. More diagrams are available at our website
http://www.emgpickups.com.
Diagrams #2 and #3 illustrate installations that have a single pickup and
do not use a selection switch.
Page 3 has diagrams that have 2 pickups and a selection switch.
Page 4 has diagrams that have 3 pickups and use the B161v4 five position
selection switch/buss. If you have the B161v4, refer to that data sheet where
more options regarding the 3-pickup instruments are available.
Keep in mind that all of the EMG Accessory controls can be substituted for one
another since they all have buffered inputs and utilize the same 5-pin connnector.
So, if you decide you would rather use the EXG instead of the SPC, simply unplug
the SPC and replace it with the EXG.
Installation Instructions:
EMG Models: SPC and RPC
SPC / RPC Page 2
Note: Reversed connector! Pins 1 and 2 are reversed.
Make sure the connectors are plugged on as shown.
All of the EMG Active controls use the same 5-pin connector
shown below.
T
R
S
FROM PICKUP
BATTERY
NEG (-)
RED
RED
OUTPUT CABLE
MASTER
VOLUME
- 9V +
BATTERY
BUSS
Diagram #2
One Pickup
One Volume
One SPC or RPC
SPC or RPC
Diagram #3
One Pickup
One Volume
One Master Tone (Passive)
One SPC or RPC
SPC or RPC
MASTER TONE
OUTPUT
T
R
S
FROM PICKUP
BATTERY
NEG (-)
RED
RED
BATTERY
BUSS
OUTPUT CABLE
MASTER
VOLUME
- 9V +
RED
NOTE:
REVERSED CONNECTOR