TIP
SLEEVE
Diagram #7
FROM TONE
OR VOLUME
Diagram #6
Attaching the bridge ground wire
6)
Refer to Diagram #6.
As mentioned on page 1, it is common to “ground” (earth)
the strings on guitars that have passive pickups.
Included with the system is a black wire with a single black
connector attached. Also included is an IDC connector for
connecting the two wires together. Insert the bridge ground wire,
and the connector wire into the IDC connector, crimp the connector
with a pair of pliers until it snaps and this will connect the two wires.
You don’t need to strip the insulation from the wires.
Push the black connector onto terminal 2 (GND) of the volume control
as shown in the diagram. This will ground the strings to the system.
PVA2-HZ / PVA5-HZ INSTRUCTIONS Page 3
Soldering to the 151 Panel Jack:
If your instrument has a long Panel Jack like the one below
you will have to solder the output cable as shown.
Ground (Black) to the Sleeve
Signal (White) to the Tip
B159A
VOLUME
250K
NECK
VOLUME
STRING GROUND WIRE
COMING FROM THE BRIDGE
BLACK WIRE INCLUDED
WITH CONNECTOR
1
2
3
4
5
6
Diagram #5
2 Pickups
Volume / Volume/ Tone
B159A
VOLUME
250K
250K
B160A
TONE
EMG
MASTER
TONE
OUTPUT CABLE
NECK
VOLUME
BRIDGE
VOLUME
(INSERT WIRES)
CRIMP
FROM NECK PICKUP
BLACK WIRE
WITH CONNECTOR
TO STRING GROUND
FROM BRIDGE PICKUP
OUTPUT
S
T
CLOSED
