ACTIVE
TONE
PASSIVE
TONE
Installation Instructions:
EMG Model: Pi2 Phase Inverter
- 9V +
NECK
VOLUME
OUTPUT
T
R
S
OUTPUT CABLE
BRIDGE
VOLUME
BATTERY
BUSS
FROM BRIDGE PICKUP
FROM NECK PICKUP
Pi2
- 9V +
NECK
VOLUME
OUTPUT
T
R
S
OUTPUT CABLE
BRIDGE
VOLUME
BATTERY
BUSS
FROM BRIDGE PICKUP
FROM NECK PICKUP
Pi2
The Pi2 is installed on guitars with two or three pickups. It is shown installed
directly at the output of either one of the pickups. The first few diagrams
show installations for two pickup guitars. The Pi2 is always wired in series
with the signal chain and can be installed on either pickup. On a two pickup
guitar the resultant sound will be the same. Since there are so many
ways to wire a guitar there are only a few diagrams shown.
If the diagram you need isn’t shown, use any of the existing EMG Wiring
diagrams and simply place the Pi2 in series with either pickup similar
to the diagrams shown.
Pi2 Instructions Page 2
Note: Reversed connector! Pins 1 and 2 are reversed.
Make sure the connectors are plugged on as shown.
All of the EMG Active controls use the same 5-pin connector
shown below.
Diagram #2
Volume / Volume / Pi2
Master Tone (Active)
NOTE:
REVERSED CONNECTOR
NOTE:
REVERSED CONNECTOR
Diagram #3
Volume / Volume / Pi2
Master Tone (Passive)
NOTE:
REVERSED CONNECTOR
Diagram #1