.390
(10)
(6)
(8)
.235
.310
SOLID
INSTALLATION INFORMATION
EMG MODELS:
LC-PA (LES CLAYPOOL MODEL)
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2021 Copyright EMG INC. All Rights Reserved.
PO BOX 4394
SANTA ROSA, CA
95402 USA
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
0230-0374rA
SPECIFICATIONS:
MODEL
:
LC-PA
Logo Color
Gold
Magnet
Type
Alnico
5
Resonant Frequency (KHz)
2.61
Output Voltage (Finger, Thumb)
2.00
Output Voltage (Thump)
8.0
Output Noise (60 Hz)
-101
Output Impedance (Kohm)
3
Current @9V (Microamps)
380
Battery Life (Hours)
1000
Maximum Supply (Volts DC)
27
3 CONNECT CABLES 5.5” (14cm)
BATTERY
BUSS
STEREO OUTPUT
JACK
1 VOLUME CONTROL (25K)
1.200
1.200
(30.48)
(30.48)
2.250
2.250
2.450
2.450
1.100
1.100
R .125
R .125
(3.17) TYP
(3.17) TYP
R .234
R .234
(5.94) TYP
(5.94) TYP
(27.94)
(27.94)
(62.23)
(62.23)
(57.15)
(57.15)
1.200
1.200
(30.48)
(30.48)
.875
.875
(22.22)
(22.22)
.750
.750
(19)
(19)
NOTE: EMG Metal Works Pickups may be direct mounted
NOTE: EMG Metal Works Pickups may be direct mounted
with either short or long adjustment screws, depending
with either short or long adjustment screws, depending
on what works best for your instrument.
on what works best for your instrument.
See Diagram #9 on page 4 for instructions on using the
See Diagram #9 on page 4 for instructions on using the
included mounting standoffs with long screws.
included mounting standoffs with long screws.
Included with each pickup:
1 TONE CONTROL (25K)
PICKUP CABLE 13.5” (34cm)
OUTPUT CABLE 6” (15cm)
BATTERY CABLE 7” (18cm)
- 9V +
Installation notes:
All EMG Active Pickups are compatible with each other. EMG Accessories, the VLPF, EXG, SPC or RPC Controls can be added to any EMG system
without requiring an extra battery. DO NOT reconnect the bridge ground wire, as EMG Active Pickups do not require string grounding. Use the
25K Ohm controls that are included for best results. If your output jack is a long panel style you will need to solder a stereo jack, like the
SwitchCraft 152B or similar. Adjust the pickup level to the strings, and experiment with a distance that works for you.
Alternate wiring diagrams are available at: emgpickups.com.
2 PICKUP IN/ OUT
BATTERY BUSS
LONG ADJUSTMENT
SCREWS (4)
MOUNTING
STANDOFFS (4)
SHORT ADJUSTMENT
SCREWS (4)
MET
AL
WORKS
