BTC CONTROL (BASS BOOST & CUT RESPONSE)
BTC CONTROL (TREBLE RESPONSE: ON/ON)
BTC CONTROL (TREBLE RESPONSE: 1 OFF/2 ON)
BTC CONTROL (TREBLE RESPONSE: 1 ON/2 OFF)
BTC CONTROL (TREBLE RESPONSE: 1 OFF/2 OFF)
- 9V +
VOLUME
OUTPUT
T
R
S
OUTPUT CABLE
NOTE REVERSED
CONNECTOR!
BATTERY
BUSS
10KHz
1KHz
20Hz
10 dB/div
10KHz
1KHz
20Hz
10 dB/div
10KHz
1KHz
20Hz
10KHz
1KHz
20Hz
10 dB/div
10KHz
1KHz
20Hz
10 dB/div
OFF/OFF
ON/ON
ON/OFF
OFF/ON
The BTC Control is easily installed by using the connector cables supplied.
Diagram #1 shows the cables connected to the BTC Control. This 5-pin
layout is the same for all EMG Accessories, so they can be interchanged.
There are a variety of ways instruments can be wired. The examples shown
here are only a few. If your instrument has different wiring than shown here
go to our website: http://www.emgpickups.com for alternate diagrams.
Diagram #2 below shows the installation of a single Volume control along with
the BTC Control.
High Frequency Response Selection:
The BTC has the added feature of allowing you to choose from 4 different
high frequency response curves. This is a nice feature especially if you are
using the BTC with passive pickups. The following diagrams show the dip-switch
positions and the graphs show the resultant frequency response.
The BTC Control is an equalizer style control, offering both boost and cut
at the same frequency locations. The controls feature a center detent (notch)
that lets you know when no equalization is in effect.
RED TO 9V + BUSS
BTC Control Page 2
NOTE REVERSED
INPUT CONNECTOR
OUTPUT TO JACK
INPUT
Installation Instructions:
EMG Model: BTC Control
BTC
CONTROL
Diagram #1
Diagram #2
Master Volume
BTC Control
