VOLUME
B122rH
VOLUME
B122rH
VOLUME
B122rH
- 9V +
- 9V +
VOLUME
OUTPUT
OUTPUT CABLE
BATTERY
BUSS
VOLUME
OUTPUT
OUTPUT CABLE
BATTERY
BUSS
BOTTOM
VIEW
BOTTOM
VIEW
BOTTOM
VIEW
VOLUME
B122rH
T
R
S
- 9V +
NECK
VOLUME
OUTPUT
T
R
S
OUTPUT CABLE
BRIDGE
VOLUME
NOTE:
REVERSED
CONNECTOR!
BATTERY
BUSS
BRIDGE PICKUP
NECK PICKUP
B3 or B64
CONTROL
NOTE:
REVERSED
CONNECTOR!
B30/B64
CONTROL
T
R
S
NOTE:
REVERSED
CONNECTOR!
B30/B64
CONTROL
PICKUP
PICKUP
Diagram #4
Volume / Volume
B30 or B64
B30/B64 Page 3
There are a variety of ways instruments can be wired. The examples shown
here are only a few. If your instrument has different wiring than shown here
go to our website: http://www.emgpickups.com for alternate diagrams.
Diagram #2 below shows the installation of a single Volume control along with
either equalizer.
Diagram #3 shows the same installation with the Volume control following the
EQ. This is the preferred wiring order with the Volume control wired last just
before the output jack
Diagram #2
Master Volume
B30 or B64
BASS
TREBLE
MID
BASS
TREBLE
MID
Diagram #3
Master Volume
B30 or B64
BASS
TREBLE
MID
2 Pickups, 2 Volume controls, B30 or 64, no selection switch
J-Bass Style wiring
Refer to Diagram #4
1) Install the Pickups and route the Pickup cables to the control cavity.
If the cables are too long, keep any excess under the pickup.
2) Mount the Volume and Tone controls into the body / pickguard.
Plug the Neck Pickup Cable onto the Neck Volume control.
Plug the Bridge Pickup Cable onto the Bridge Volume control.
3) Plug a coax cable from the Neck Volume control to the Bridge Volume
control.
4) Plug a coax cable from the Bridge Volume control to the BTS Control.
5) Plug the output cable from the EQ Control and connect the output
wires to the output jack by pushing the connectors on as shown.
WHITE wire onto the TIP (T) contact,
BLACK wire onto the SLEEVE (S) contact
BLACK Battery Negative wire onto the RING (R) contact.
6) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud)
along with the RED of the battery clip.
Extra pins on the V+ Supply Buss are for EMG Accessories.
7) Put the battery in the insulating foam piece provided and place it securely
in the control cavity.
We suggest that you plug in the instrument and test it before closing the
control cavity.
Installation Instructions:
EMG Model: B30 or B64
PICKUP
B30 or B64
MASTER
VOLUME
OUTPUT
JACK
EQ
PICKUP
B30 or B64
MASTER
VOLUME
OUTPUT
JACK
EQ
