5. Double click on the
Device
icon under the
HART Modem
tab, then
select the
Configure/Setup
tab. Use the
Direct Connection
menu.
6. Start configuring the device following the steps beginning from
AMS Device Manager configuration changes are implemented when
the
Apply
button is selected.
Figure 3-2: Connection with HART Modem and AMS Device
Manager
A. Rosemount 4390 Wireless Transmitter
B. HART Modem with lead and clip connector kit
C. Computer with AMS Device Manager installed
3.6
Joining to a wireless network
To communicate with the Wireless Gateway, and ultimately the host
system, the transmitter must be configured to communicate over the
wireless network. This step is the wireless equivalent of connecting wires
from a transmitter to the host system.
Procedure
Using the AMS Trex or AMS Device Manager, enter the Network ID and Join
Key so they match with the Network ID and Join Key of the Gateway and the
other devices in the network.
Note
If the Network ID and Join Key are not identical, the transmitter will not
communicate with the network. The Network ID and Join Key can be
obtained from the Gateway on the
System Settings
→
Network
→
Network
Settings
page of the Wireless Gateway web-based user interface.
Quick Start Guide
April 2021
12
Emerson.com/Rosemount
