Emerson USB Fieldbus Interface, User Manual, Page: 33 / 59

Update device catalog Figure 6-1:
3. Click
Yes
when prompted to create a new PACTware device catalog.
4. Close the device catalog when done.
6.3 Configure fieldbus devices in an FDT Frame Application
Notes
• Install the Communication DTM software and the DTM Library first before configuring fieldbus
devices in an FDT Frame Application. For more information, see Section 3.3 and Section 3.4 .
• If necessary, update the DTM library. For more information, see Section 6.2 .
• Make sure the USB Fieldbus Interface and fieldbus devices are correctly set up and that the
Fieldbus Interface Configuration utility is installed and running. For more information, see
Section 3.5 and Chapter 4 .
1. Launch PACTware.
2. From the Project pane, right-click
HOST PC and click Add device .
May 2014 User's Manual
33