16
U.L. Model No.: CF4900
7. No Light Cover Assembly
(continued)
7.4
Place the no light cover inside the glass assembly
(Figure 26).
Make sure the outer ring of the no light cover is
protruding through the glass assembly.
Rotate the three glass shade clamps over the inner
edge of the no light cover.
Be sure to keep the rubber pad beneath each clamp to
ensure proper clamping.
7.5
Tighten the three glass assembly screws to secure the
assembly (Figure 26).
RETIGHTEN GLASS ASSEMBLY
SCREWS (3)
GLASS SHADE
CLAMPS (3)
GLASS ASSEMBLY
GLASS SHADE CLAMP
RUBBER PAD
CLAMP SCREW
NO LIGHT
COVER
ROTATE SHADE CLAMPS (3)
INSTALL THE
NO LIGHT
COVER
Figure 26
7.3
Loosen the three glass assembly screws on the inside
of the glass assembly (Figure 25).
Rotate the three glass shade clamps to free the glass
shade.
Be sure not to loosen the rubber pads beneath each
clamp, needed for proper clamping.
Carefully remove the glass shade by lifting it out of the
glass assembly and store in a safe place for possible
future use (Figure 25).
LOOSEN GLASS ASSEMBLY
SCREWS (3)
GLASS SHADE
CLAMPS (3)
REMOVE
GLASS
SHADE
GLASS ASSEMBLY
GLASS SHADE CLAMP
RUBBER PAD
CLAMP SCREW
GLASS SHADE
ROTATE SHADE CLAMPS (3)
Figure 25
BP7485 Southtowne CF4900 12/4/13 10:15 AM Page 16
