Page: 1
STCCAT6P0EI
Introduction
The SolaHD STCCATCAT6P0EI is designed for use with Category 6 Power-Over-Ethernet transmission line
applications. It limits surges and transients at computers and video equipment.
The STCCATCAT6P0EI is available with an isolated ground option to be used at the equipment end in order to
help prevent circulating ground currents.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E,
NOM-029-STPS or CSA Z462.
•
This equipment must only be installed and serviced by qualified electrical personnel.
•
Turn off all power supplying this equipment before working on or inside equipment.
•
Always use a properly rated voltage sensing device to confirm power is off.
•
Replace all devices, doors and covers before turning on power to this equipment.
•
This equipment must be effectively grounded per all applicable codes. Use an equipment-grounding conductor
to connect this equipment to the power system ground.
•
Confirm that the Surge Protective Device voltage rating on the module or nameplate label is not less than the
operating voltage.
•
Do not place this product in service on any line capable of supplying more than 750 mA continuously.
Failure to follow these instructions will result in death or serious injury.
WARNING:
This product can expose you to chemicals including DINP, which is known to the State of California
to cause cancer, and DIDP which is known to the State of California to cause birth defects or other reproductive
harm. For more information go to: www.P65Warnings.ca.gov.