Emerson Rosemount FCL, Reference Manual

Page: 35 / 108

1. If a security code has been programmed, pressing MENU causes the security screen
to appear.
2. Enter the three-digit security code.
3. If the entry is correct, the main Menu screen appears. The user has access to the
sub-menus the code entitles him to.
4. If the entry is wrong, the Invalid code screen appears.
4.4.2 Assign security codes
See Configuring security settings .
4.4.3 Bypassing security codes
Call the factory.
4.5 Using hold
4.5.1 Putting sensor in hold
To prevent unwanted alarms and improper operation of control systems or dosing pumps,
place the alarms and outputs assigned to the sensor in hold before removing it for
maintenance.
Hold is also useful if calibration will cause an out of limits condition. During hold, outputs
assigned to the sensor remain at the last value, and alarms assigned to the sensor remain
in their present state.
Once in hold, the sensor remains in hold until hold is turned off. However, if power is loss
than restored, hold is automatically turned off.
4.5.2 Using the hold function
To put the transmitter in hold, complete the following steps.
Procedure
1. Press MENU .
The main
Menu
screen appears.
Reference Manual Display and operation
00809-0100-3412 May 2019
Rosemount FCL 1056 35