Emerson Rosemount CT4400, Reference Manual

Page: 23 / 106

2 Install
2.1 Site selection and rack mounting
WARNING
HEAVY ITEM
Handle the analyzer with caution during unpacking, installing, maintaining, and
transporting to prevent crushing of hands, feet, or other body parts.
The analyzer weighs 33 lb (15 kg) for the half rack system and 66 lb (30 kg) for the full rack
system. Rosemount recommends that the analyzer is moved by a minimum of two people
when lifting and transporting the equipment.
Failure to properly handle the analyzer may cause injury to personnel, wear suitable
protective gloves and protective footwear.
Procedure
1. The analyzer MUST be installed in an enclosed environment that is protected from
the elements, humidity, and temperature variations for optimum performance.
2. Site selection for analyzer installation
MUST
account for the handles on the front
face of the full rack system and rear entry for the cable and tube connections (see
Figure 2-1 and Figure 2-2 ).
3. Screw in rubber feet have been fitted to the base of the analyzer – if required these
can be removed to aid assembly into the rack system being provided.
4. The full rack system has additional slotted holes on the front face for securing the
analyzer to the rack system (see Figure 2-2 ).
5. The minimum tubing and cabling allowance defined in Figure 2-1 and Figure 2-2 at
the rear of the analyzer MUST be accounted for when installing the rack system.
Figure 2-1: Half Rack Installation Requirements
A. Four off M4 mounting holes for customer supplied mounting ears (if required)
B. Three off M4 mounting holes for customer supplied rail (if required)
Reference Manual Install
00809-0100-4244 January 2020
Reference Manual 23