Emerson Rosemount CCO 5500, Reference Manual

Page: 15 / 124

2 Install
WARNING!
Before installing this equipment, read Essential Instructions . Failure to follow safety instructions
could result in serious injury or death.
WARNING!
ELECTRICAL HAZARD
Install all protective equipment covers and safety ground leads after installation. Failure to
install covers and ground leads could result in serious injury or death.
WARNING!
ELECTRIC SHOCK
Before making any electrical connections, make sure the AC power supply is first switched off.
Failure to do so could cause personal injury or even death. Make sure that the voltage and
frequency of the AC supply match the designations on the analyzer component tags.
2.1 Unpack the equipment
A typical Rosemount
™
CCO 5500 Carbon Monoxide (CO) Analyzer should contain the
following items.
Refer to Figure 1-1 for an illustration of each of these components. Record the part
number, serial number, and order number for each major component of your system.
1.
Source with 33 ft. (10 m) of cable and air purge
2. Receiver with 33 ft. (10 m) of cable and air purge
3. Interconnect cable 3 ft. (0.91 m)
4. Control unit
5. Power supply
6. Gaskets (four)
7. Selected screws and washers
2.2 Safety considerations
Power is supplied to the whole system via the power supply unit. During installation, do
not connect the system to the facility power source until all units are in place and fully
wired. If used, keep the isolating valves closed. You must turn off the compressed air
Install
Reference Manual 7