Emerson Rosemount 928, Reference Manual

Page: 11 / 204

2 Configuration
2.1 Overview
This section contains information on configuring the transmitter, including the sensor,
using Field Communicator or AMS Wireless Configurator. It also includes sensor calibration
information.
2.2 Safety messages
Instructions and procedures in this section may require special precautions to ensure the
safety of the personnel performing them.
WARNING
Follow installation guidelines.
Failure to follow these installation guidelines could result in death or serious injury.
Ensure that only qualified persons perform the installation.
WARNING
Explosions
Explosions could result in death or serious injury.
Before connecting a handheld communication device in an explosive atmosphere,
make sure that the instruments are installed in accordance with Intrinsically Safe or
non-incendive field wiring practices.
Verify that the operating atmosphere of the transmitter is consistent with the
appropriate hazardous locations certifications.
WARNING
Electrical shock
Electrical shock could cause death or serious injury.
Use extreme caution when making contact with the leads and terminals.
The power module may be replaced in a hazardous area. The power module has a
surface resistivity greater than one gigaohm and must be properly installed in the
wireless device enclosure. Take care during transportation to and from the point of
installation to prevent electrostatic charge buildup.
The surface resistivity of the antenna is greater than one gigaohm. To avoid
electrostatic charge buildup, do not rub or clean the antenna with solvents or a dry
cloth.
Substitution of components may impair intrinsic safety.
Reference Manual Configuration
00809-0100-4928 September 2019
Rosemount 928 11