8
Reference Manual
00809-0200-4705, Rev AB
Configuration
May 2017
Configuration
Wiring the transmitter
For the R1 option (remote mount), if the turbine meter or pulse output device is installed in a
high-voltage environment and a fault condition or installation error occurs, the sensor leads and
transmitter terminals could carry lethal voltage. Use extreme caution when making contact with the
leads and terminals.
Use the following steps to wire the sensor and power supply to the transmitter:
1. Remove the transmitter enclosure cover.
2. Attach the turbine meter leads according to the diagram
Note
For noisy electrical environments, it is best practice to ground the loop accordingly.
3. Connect the black power module.
4. Verify the connection and power by viewing the LCD display and seeing the power up sequence.
5. Replace the cover and tighten.
Figure 2-1. Rosemount 705 Transmitter Terminal Block
A. Pulse input connection
B. HART
®
terminal connection
C. Terminal block ground connection
Note
Connections are not polarity sensitive.
2.3
Configuring the transmitter on the bench
When using a Field Communicator, any configuration changes must be sent to the transmitter using the
Send
key (
F2
). AMS
™
Device Manager configuration changes are implemented when the
Apply
button is
clicked.
A
C
B
Summary of Contents for Rosemount 705
