MVME7616E Transition Module Installation and Use (6806800A43B
)
General Information
Specifications
18
1.9
Specifications
The MVME761 transition module specifications are shown in the next table.
1.10
Cooling Requirements
The MVME761-0x1 is tested to operate under forced air cooling with an incoming air
temperature range of 0 degrees C to 55 degrees C. Adequate cooling can be achieved with air
flowing over the module at 5 cubic feet per minute. The exact amount of airflow required for
cooling depends on the ambient air temperature and the type, number, and location of modules
and other heat sources.
1.11
FCC Compliance
The MVME761-0x1 was tested in an FCC-compliant chassis, and meets the requirements for
Class A equipment. For minimum RF emissions, it is essential that you implement the following
conditions:
z
Install shielded cables on all external I/O ports
z
Connect conductive chassis rails to earth ground to provide a path for connecting shields
to earth ground
z
Tighten all front panel screws
Table 1-6 MVME761-0x1 Specifications
Characteristics
Specifications
Power Requirements
+12 Vdc, 100 mA typical, 200 mA maximum
-12 Vdc, 100 mA (for some of the SIMs)
Operating temperature
0
o
to 55
o
C at chassis point of entry of forced air (approximately
5 CFM)
Storage temperature
-40
o
to +85
o
C
Relative Humidity
5% to 90% (non-condensing)
Board Size
(excluding front panel)
Height: 9.187 inches(233.35 mm)
Height: 3.200 inches(80.00 mm)
Thickness: 0.063 inches (1.60 mm)
