Emerson MVME55006E, Installation And Use Manual

Page: 59 / 146

RAM55006E Memory Expansion Module
MVME55006E Single Board Computer Installation and Use (6806800A37H)
59
3.3.3 Clocks
The host board provides one SDRAM clock to the memory expansion connector. The frequency
of the RAM5500 CLKS is the same as the host board. This clock is used to generate the on-board
SDRAM clocks using a phase lock loop zero delay clock driver.
3.4 Memory Expansion Connector Pin Assignments
The P1 connector on the RAM5500 is a 140-pin AMP 4mm Free Height mating plug. This plug
includes common ground contacts that mate with standard AMP receptacle assemblies or AMP
GIGA assemblies with ground plates. Refer to
Memory Expansion Connector (P4) on page 105 for
the P4 pin assignments.
*Common GND pins mate to a GIGA assembly with a ground plate. The GIGA assembly is an
enhanced electrical performance receptacle and plug from AMP that includes receptacles
loaded with contacts for grounding circuits at 9 or 10 signal circuits. These ground contacts
mate with grounding plates on both sides of the plug assemblies.
Table 3-2 RAM5500 Connector (P1) Pin Assignments
Pin Signal Signal Pin
1 GND* GND* 2
3 DQ00 DQ01 4
5 DQ02 DQ03 6
7 DQ04 DQ05 8
9 DQ06 DQ07 10
11 +3.3V +3.3V 12
13 DQ08 DQ09 14
15 DQ10 DQ11 16
17 DQ12 DQ13 18
19 DQ14 DQ15 20
21 GND* GND* 22
23 DQ16 DQ17 24
25 DQ18 DQ19 26