Emerson Micro Motion 4200, Installation Manual

Page: 7 / 40

The connections between the transmitter and sensor are 9-wire, and do not require field
wiring on the integral mount version.
The I/O connections consist of 2 channels, each channel being 2-wire. Power must be
supplied to Channel A for the transmitter to operate, while Channel B connections are
optional.
Figure 1-3: 4200 transmitter -- Remote mount
A. Transmitter housing cover
B. Clamping ring
C. Junction box
The transmitter is installed remotely from the sensor. The 9-wire connection between the
sensor and transmitter must be field wired. Power supply and I/O must be field wired to
the transmitter. The sensor connection is in the junction box.
1.5 Installation checklist
□
Safety messages are provided throughout this content to protect personnel and
equipment. Read each safety message carefully before proceeding to the next step.
□
When choosing a location for components, refer to the following guidelines:
— See the sensor installation manual for information on locating the sensor with
remote-mount or extended-mount electronics.
Installation Manual Planning
MMI-20058013 April 2019
Installation Manual 7