60 Chapter 6 Application Of INTELLISLOT
Liebert. PEX+Series Precision Air Conditioner User Manual
Normally,
Boot mode
should be set to
Static
. If the user network can automatically distribute the address, select
DHCP, and the IP Address, Netmask and Default Gateway do not need to be set. If the boot mode is static, Type
‘3’, ‘4’
and
‘5’, and then respectively type the corresponding IP address, Netmask and Default Gateway according to the
prompt. These three parameters should be given by the user.
4. Press the ESC button to return to the main interface, as shown in the following figure. If you type
‘x’, the setting can
be saved. After the setting is saved, the TCP/IP communication card will be restarted.
5. On the main interface, typing
‘5’ can view whether the communication status between the communication card and
the Liebert.PEX+ series air conditioner is normal, as shown in the following figure.
6.3.4 Setting SNMP Parameters Of TCP/IP Communication Card
After the HyperTerminal of the TCP/IP communication card is set, you can set the parameters of this communication
card. The detailed setting procedures are as follows:
1. Type the IP address of the TCP/IP communication card in the address bar of the IE browser. If the interface shown in
Figure 6-8 appears, it indicates that the communication between the communication card and the iCOM controller is
abnormal. If the
State
shows
Completing
or
In Process
, it indicates that the communication card is communicating
with the iCOM controller.
