Emerson Liebert Intellislot Unity Card, User Manual

Page: 21 / 92

Installation
11 Liebert
®
IntelliSlot
™
Unity
™
Card User Manual
7. Re-enter the general user’s password to confirm it.
8. Click Save button to confirm the changes or Cancel to discard them.
Figure 2-2 Change administrator and general user names and passwords
2.3 Configure the Card
The Liebert IntelliSlot Unity card requires minor configuration, such as choosing the IP/Web
communication interface, serial RS-485 communication interface, or both. The default for IP/Web
communication is IPv4, but this can be changed to IPv6 for greater security; contact your network
administrator to determine whether it is compatible with your network. To choose the communication
interface refer to
Figure 2-3 :
1. Select Communications tab > Configuration > Network .
2. Enable the protocol, either IPv4 or IPv6, that will be used to communicate with the Liebert IntelliSlot
Unity card and with the Liebert equipment.
a. Click either IPv4 or IPv6 .
b. Click Edit .
c. When prompted with a login display, enter the user name and password (the defaults are Liebert
and Liebert ).
d. Click to check enabled .
e. Enter the desired or assigned IP address along with the rest of the required networking
information. Contact your system administrator if necessary.
NOTE
Record the new user names and passwords and save them in a secure place where they can be
found if forgotten.
A lost password cannot be retrieved. If the password is lost, the card must be reset to factory
defaults and reconfigured.
Administrator User
Name and Password
General User Name
and Password