Options—Installation
19
4.7
Tool-Less Blanking Panels
Tool-less blanking panels can be snapped onto the Knurr DCM 19" rails to block unused portions of
the rack. Blocking the open areas enhancees airflow through the rack equipment. The blanking
panels are available in 1U (Part # 010200087) and 2U (Part # 010200088). Attach the panels by
snaping the tabs on the back into square holes in the 19" rails as shown in Figure 16.
Figure 16 Installing tool-less blanking panels
NOTE
Emerson recommends inserting blanking panels in any unused portion of the rack to promote
proper airflow through the rack equipment.
1U Tool-Less Blanking Panel
Installed in Rack
Front View
2U Blanking Panel;
Snap Fittings on Rear
fit into 19" rails
