6
ETL Model No.: CF320
3. Ceiling Fan Assembly
(Continued)
COUPLING
COVER
COUPLING COVER
GROMMET
MOTOR
HOUSING
4.5" DOWNROD
Figure 5
3.5
Make sure the grommet is properly installed in the coupling
cover, then slide the coupling cover on the downrod until it
rests on the motor housing (Figure 5).
HAIRPIN
CLIP
CLEVIS
PIN
MOTOR
COUPLING
HAIRPIN
CLIP
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 4
CEILING
COVER
4.5" DOWNROD
Figure 6
3.6
Place the ceiling cover over the downrod (Figure 6).
Be sure that the ceiling cover and the coupling cover are
both oriented correctly (Figure 6).
3.4
Align the clevis pin holes in the downrod with the holes in
the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 4).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor coupler
is properly installed and securely tightened.
Retighten the two Phillips head set screws to secure the
downrod to the motor (Figure 4).
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
WARNING
!
BP7514 CF320 Keane 12 2015_CF320 1/7/16 10:42 AM Page 6