12
Operating Your
Ceiling Fan
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing of the remote
control.
Your remote control (Figure 19) has full
control of your fan and light.
1. Restore electrical power to the outlet
box by turning the electricity on at the
service panel.
2. To set the desired fan speed, press the
HIGH, MED, or LOW buttons to oper-
ate your fan on high, medium, or low
speed.
3. To turn your fan off, press the OFF
button.
4. To change the airflow direction of the
fan blades, press the REV button. The
direction the fan blades turn will change
each time the REV button is pressed.
5. To turn the downlight on, press and
release the DN button. The light will
turn on at the light intensity previously
selected.
6. To turn the uplight on, press and
release the UP button. The light will
turn on at the light intensity previously
selected.
7. To vary the intensity of the light, hold
the DN or UP button down until the
desired light intensity is reached, then
release the button.
Red light should turn on when any but-
ton is pressed. If the light does not
come on, replace the battery.
®
OFF
REV
LOW
MED
HIGH
UP
DN
REMOTE
CONTROL
TRANSMITTER
Figure 19
Installation of
Storage Bracket
A storage bracket is supplied with the
remote control for holding the transmitter
when not in use. If you desire to use the
bracket, use the two screws (supplied)
and install it on a wall that is away from
excess heat or humidity.
Emerson High Country 3/10/05 9:32 AM Page 12
