at the lower temperatures
Unit has no power.
•
Check the wall outlet for power. Make sure the outlet is not
controlled by a wall switch
The inside temperature
does not seem correct
•
Make sure the cooling vents on each side of the cellar are not
obstructed. Have at least 5Inch (15cm) of space on each side of
unit.
•
The unit will have difficulty in cooling if the set temperature is
32°F (18°C) below the ambient temperature.
Example: if the ambient temperature is 86°F (30°C), the unit
will have difficulty cooling to 54°F (12°C).
•
When using the unit for the first time, it can take up to 24 hrs to
reach the desired temperature
The unit does not
operate
•
It may not be plugged into the wall socket
•
Make sure the wall socket is functional by testing another
electrical appliance in the power socket
•
Make sure the circuit breaker is not tripped or a fuse is blown
There is a puddle of
water under / around the
wine cellar
•
This wine cellar features a self-evaporation system. An external
drip tray is therefore not required for accumulating condensation.
If water forms under / around the wine cellar, the humidity level in
the room is too high. Either try to lower the humidity level in the
room (using for example a dehumidifier) or place the wine cellar
in an another room
The unit will not cool.
Power is On.
Make sure there are at least 3-5 bottles in the unit.
Allow at least 24 hours for the internal temperature to adjust
properly.
The interior temperature can be set to between 44°F and 66°F on the
control panel. Due to technological limitations, the wine cellar has the
ability to maintain a temperature that is 66°F cooler compared to the
ambient temperature. Therefore, if the ambient temperature is higher
then 97°F, the wine cellar might not be able to reach an interior
temperature of 44°F to 66°F as per the control panel settings.
To achieve accurate temperature control, the unit should
not
be used
or operated in any of the following locations:
•
in a sunny place
•
in a room with poor air circulation such as a garage
•
near another heat producing appliance (dishwasher, oven,
refrigerator).
•
with an outlet shared with a refrigerator as it will drain power from
the unit.
•
built-in a wall recess, niche or cabinet.
•
in a cabinet or closet.
And remember to have at least 5Inch (15 cm) of space on each
side of unit.
General Statements
•
The unit can be manually set using the
▲
and
▼
buttons The
minimum setting is45°F (7°C) and maximum is 64°F (18°C).
•
The unit does not use any CFC’s. There is no compressor inside
this unit.
•
The cooling system is called a Peltier System
