Instruction Manual
D104302X012
CML Electric Actuator
January 2019
2
Actuator Specifications
Table 1. CML Actuator Specifications
ACTUATOR
CML-250
CML-750
ACTUATOR HOUSING
Cast Aluminum
ENVIRONMENTAL RATINGS
FM, CSA, ATEX, IEC
OPTIONAL RATINGS
FM, CSA, ATEX, IEC
STANDARD ENCLOSURE
FM
NEMA 4 and 6 / IP67
Class 1 Div 1 Gr C, D
Class II Div I E, F, G
STANDARD TEMPERATURE RATING
-30°C to +70°C (-22°F to +158°F)
HAZAROUS AREA TEMPERATURE RANGE
-20°C to +65°C (-4°F to +150°F)
CONDUIT CONNECTION
3/4" - 14 NPT (M25 x 1.50p optional)
MOTOR TYPE
Brushless DC
OPTIONAL VOLTAGES
120VAC, 240VAC, 24VDC
(1)
STANDARD POWER
120VAC/240VAC
THRUST RATING
250 lbs Mod/Run (1112.1 N)
375 lbs Seating (1668.1 N)
750 lbs Mod/Run (3336.2 N)
1125 lbs Seating (5004.2 N)
THRUST ADJUSTABILITY
60% - 150% Rated Thrust
MAX SPEED
0.13 in/sec
(2)
STANDARD CONTROL
Full range 4-20mA / Split Range 4/12 or 12-20mA
**optional: 0-5Vdc and 0-10Vdc
STANDARD FEEDBACK
4-20mA loop powered feedback
(3)
STANDARD CONTROL OPTIONS
(SPECIAL)
Discrete On/Off RIRO [24VDC or 120VAC control], HART, Foundation
Fieldbus, DeviceNet, Profibus, Modbus, Pakscan
HMI/GUI SETUP
LCD - text
MODULATING DUTY CYCLE
Unrestricted and Continuous
RESOLUTION
0.2% (adjustable deadband 0 - 10% of analogue signal)
SENSITIVITY
0.2%
RESPONSE TIME
20 milliseconds
STANDARD FAILURE ACTION
Close valve / Open valve / Hold-in-Place / Fail to Position on loss of input signal (selectable).
Holds in place on power failure (standard)
CUSTOMER SETTINGS SAVED
Yes, Standard
WEIGHT (ACTUATOR ONLY)
8.3 kg (18.4 lbs)
11.5 kg (25.4 lbs)
POWER BACK-UP OPTION
Available: Super Capacitors. Fail to Position on Loss of Power.
Adjustable to Fail Closed, Fail Open, Fail to Position, Fail in Place
LOWER CONTROL OPTION
Available: Separate option. Local controls come standard with Super Capacitor Power Back-up
1. 24VAC not available.
2. Adjustable from 50 to 100%.
3. Includes 2 adjustable relay outputs.
WARNING
Always wear protective gloves, clothing and eyewear when performing any installation operations to avoid personal
injury.
Personal injury or property damage caused by sudden release of pressure or bursting of pressure retaining parts may result
if service conditions exceed those for which the product was intended. To avoid injury or damage, provide a relief valve for
over pressure protection as required by government or accepted industry codes and good engineering practices.
Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
If installing into an existing application, also refer to the WARNING at the beginning of the Maintenance section in this
instruction manual.
