Emerson FIELDVUE DVC6200f, Instruction Manual

Page: 25 / 326

Installation
November 2010 13
W9705
RSHAFT END
ASSEMBLY
90 DEG
AVAILABLE CONSTRUCTIONS:
SSTEM #19 ASSEMBLY (19 mm / 3/4 INCH)
SSTEM #25 ASSEMBLY (25 mm / 1 INCH) AVAILABLE CONSTRUCTIONS:
SSTEM #38 ASSEMBLY (38 mm / 1-1/2 INCH)
SSTEM #50 ASSEMBLY (50 mm / 2 INCH)
SSTEM #100 ASSEMBLY (100 mm / 4 INCH) AVAILABLE CONSTRUCTIONS:
SSTEM #1 ROLLER ASSEMBLY
RSHAFT #1 WINDOW ASSEMBLY
(FISHER 2052 SIZE 2 & 3, 1051/1052
SIZE 40-70, 1061 SIZE 30-100,
SLIDING-STEM > 100 mm (4 INCHES)
RSHAFT #2 WINDOW ASSEMBLY
(2052 SIZE 1, 1051/1052 SIZE 20
−
33)
Figure 2-2. Magnet Assemblies
There are a variety of mounting brackets and kits that
are used to mount the DVC6200f to different
actuators. Depending on the actuator, there will be
differences in fasteners, brackets, and connecting
linkages.
Each mounting kit will include one of the magnet
assemblies illustrated in figure 2-2.
If ordered as part of a control valve assembly, the
factory will mount the digital valve controller on the
actuator and calibrate the instrument. If purchased
separately, you will need a mounting kit to mount the
digital valve controller on the actuator. Each mounting
kit includes detailed information on mounting the digital
valve controller to a specific actuator. Refer to table
2-1 for the more common Fisher actuator mounting
instructions, available at www.fisher.com or your
Emerson Process Management sales office.
For general mounting guidelines, refer to the
DVC6200f quick start guide (D103410X012), available
at www.fisher.com or your Emerson Process
Management sales office.
INDEX MARK
VALID TRAVEL
RANGE 50 mm
(2 INCH) SHOWN
MAGNET ASSEMBLY
(ATTACHED TO VALVE STEM)
W9706
Figure 2-3. Travel Range
2