Maintenance and Troubleshooting Manual
Section 3: Meter maintenance
3-9000-764 Rev F
December 2017
Acquisition Module replacement
45
3.5.4
Acquisition Module replacement
1.
Remove power to the meter.
2.
Refer to
for the tools required to complete this procedure.
3.
If the installation has rigid conduit, use a medium size crescent wrench and loosen the
hex nuts on the Transmitter Electronics Enclosure. This should allow enough slack to
remove the Transmitter Electronics Enclosure from the Base Enclosure. If the
installation uses flexible conduit, you may not need to disconnect it from the
Transmitter Electronics Enclosure.
Figure 3-29 Conduit removal
A. Transmitter electronics enclosure
A.
B. Conduit bolts
B.
