Emerson daniel 1500 series, User Manual

Page: 37 / 104

2 Operating conditions and
specifications
Topics covered in this chapter:
• Operating conditions for the liquid turbine meter
• Specifications for the LTM
2.1 Operating conditions for the liquid turbine
meter
Operating conditions for the liquid turbine meter Table 2-1:
Parameter type Description
Fluid phase Liquid
Fluid(s) measured • Low/medium viscosity crude oils and condensates
• Refined products and intermediates (e.g.: gasoline, die-
sel, kerosene, light fuel oils, jet fuel, LPG, butanes, naph-
tha, alkylate, reformate, straight run gasoline, cat-
cracked gasoline
)
• Petrochemicals (e.g.: benzene, toluene, xylenes, cu-
mene, olefins, pyrolysis gasoline )
• Natural gas liquids
Process temperature
(Carbon steel flanges) -29 ºC to 60 ºC (-20 ºF to 140 ºF)
Optional process temperature
(Carbon steel flanges) -29 ºC to 204 ºC (-20 ºF to 400 ºF)
Process temperature
(Stainless steel flanges) -40 ºC to 60 ºC (-40 ºF to 140 ºF)
Optional process temperature
(Stainless steel flanges) -40 ºC to 204 ºC (-40 ºF to 400 ºF)
Fluid static pressure The maximum working pressure for the Daniel Series 1500
Liquid Turbine Meter is based on the temperature/pres-
sure rating of the ANSI B16.5 flanges. For maximum work-
ing pressures at intermediate temperatures refer to ANSI
B16.5.
Fluid flow rate 100 BPH – 60000 BPH
Pressure drop At maximum flow of normal flow range on water 4 psi.
Ambient temperature -40 ºC to 60 ºC (-40 ºF to 140 ºF) (T
amb
is an electrical speci-
fication)
Operating conditions and specifications
User manual 27