ISIS I&C Manual
In-Store Information Server (ISIS) Installation Instructions • 11
1.20.4.REFLECS Connection
Refer to
for a closer look at connectors and
LEDs for the ISIS. To connect a REFLECS controller to
the ISIS, follow these steps:
1. Take the supplied CPC-approved network ca-
ble and plug the 9-pin connector into RS-232
COM 1.
2. Plug the 4-pin connector into the COM C port
on the REFLECS. (For more information, see
the CPC
Refrigeration Monitor and Case
Control Installation and Operation Manual
)
Figure 1-7
- ISIS to REFLECS
NOTE: The Ethernet connection must be
made prior to applying power to the control-
ler.