22
C6.1.9/0219/E
2.16.3 Location of the "Hot Key" plug connection on the XCM25D controller
The "Hot Key" plug connection is located on the upper left corner of the XCM25D.
Figure 21: Location of "Hot Key" plug connection
2.16.4 How to program a "Hot Key" from the controller (upload)
▪
Program one controller with the front keypad.
▪
When the controller is on, insert the "Hot Key" and press the
UP
key; the
"uPL"
message
appears followed a by a flashing "
End
" label.
▪
Press the
SET
key and the "
End
" label will stop flashing.
▪
Turn the controller off, remove the "Hot Key" and then turn it on again.
NOTE: The "Err" message appears in case of a failed programming operation. In this case
push the key again if you want to restart the upload or remove the "Hot Key" to abort the
operation.
2.16.5 How to program a controller using an Emerson "Hot Key" (download)
▪
Turn the controller off.
▪
Insert a pre-programmed "Hot Key" into the 5-pin receptacle and turn the controller on.
▪
The parameter list of the hot key will be automatically downloaded into the controller memory.
The "
doL
" message will blink followed a by a flashing "
End
" label.
▪
After 10 seconds the controller will restart working with the new parameters.
▪
Remove the "Hot Key".
NOTE: The message "Err" is displayed in case of a failed programming operation. In this case
turn the unit off, then on again if you want to restart the download, or remove the "Hot Key"
to abort the operation.
