17
Adjusting the Wake-up Times
This clock radio has two separate wake-up alarms that can be set and used
independently. To set or adjust the wake-up times please proceed as follows:
1.) Depress and hold the
ALARM SET/
DISPLAY
button for at least two seconds
until just the Hour digits and the
AL1
(Alarm 1) indicator are flashing.
2.) While the
AL1
Hour digits are flashing press the
or
buttons repeatedly
to set the display to the correct wake-up hour.
Example:
7:00
AM
Observe the
PM
indicator to make sure you have set the wake-up hour correctly.
If the
PM
indicator is ‘On’ the wake-up time displayed is “PM”. If the PM indicator
is ‘Off’ the wake-up time displayed is “AM”.
3.) When the correct wake-up hour is
flashing press the
CLK. ADJ/PROG.
button again.
The Hour digits stop flashing and the minute digits begin to flash.
4.) While the Minute digits are flashing press
the
or
buttons repeatedly to set
the display to the correct wake-up
minute.
5.) When the desired Alarm 1 wake-up time is showing on the display, press the
CLK. ADJ/PROG.
button to store the Alarm 1 wake-up time in the timer memory.
The
AL2
(Alarm 2) indicator and the
Alarm 2 Hour digits begin flashing.
NOTE
: If you do not need to adjust the Alarm 2 wake up time you may just
wait 10 seconds. After 10 seconds the Alarm 2 display stops flashing and
the clock returns to the correct time.
CKD1100_052107.p65
21/5/2007, 10:44
17
