Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capa-
ble of withstanding a load of at least 50 pounds.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time
and remove the existing light fixture.
6.
Turn fan assembly upside down in preparation for
mounting fan blade assemblies.
IMPORTANT: THE SIDE OF THE FAN BLADE
HAVING THE RIB LINE MUST BE FACING
UPWARDS AS SHOWN IN FIGURE 5.
7.
Mount blade flanges to fan blades using three
M5 x 6 washer head screws per blade (Figure 5).
NOTE: Remove and discard the five shipping
spacers and screws from the motor hub.
8.
Attach blade assembly to motor using two
M6 x 14 flange screws with lockwasher preassem-
bled in flange. Make sure the screws are tightened
securely (Figure 6). Repeat this procedure for other
four blade assemblies.
NOTE: Take care not to scratch fan housing when
installing blades.
9.
You have now completed the assembly of your
new ceiling fan. You can now proceed with hanging
and the electrical wiring of your fan.
Electrical Requirements
5
BLADE FLANGE
FAN BLADE
M5 x 6 WASHER HEAD
BLADE SCREW (3)
RIB LINE
(THIS SIDE UP)
Figure 5
SWITCH HOUSING
MOTOR
HUB
M6 x 14 FLANGE SCREWS
WITH LOCKWASHERS (2)
Figure 6
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked “Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less”, and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these instruc-
tions should be done or approved by a licensed elec-
trician.
WARNING
!
U.L. Model No.: CF654
