17
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF330
7.6
Disconnect electrical power to the branch circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Outlet Box.
Before installing Wall Control, place Wall Control in
“OFF” mode by pushing “ON/OFF” Switch to the “OFF”
position.
Connect the Wall Control Black Wire with the Yellow
Label marked “To Power Supply” to the “Hot” Wire in
the Wall Box. Securely connect Wires with
Wire Connector (supplied) (Figure 27).
Connect the Wall Control Black Wire with Blue Label
marked “To Fan” to the “Load” (Black) Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 27).
Connect the Wall Control Green Ground Wire to the
Bare Copper Wire or Green Ground Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 27).
TO P
OWE
R
SUP
PLY
SW406 FAN/LIGHT
WALL CONTROL
WALL
BOX
BL
AC
K
BL
AC
K
HOT
NEUTRAL
WIRES
DECORATIVE WALL PLATE
SCREWS (2)
SWITCH COVER
G
R
EE
N
G
R
O
U
N
D
TO
FA
N
TO
120VAC SOURCE
TO LOAD
GROUND
Figure 27
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
7.5
This control is designed to operate only one ceiling fan
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
Remove the Faceplate and Screws from the Existing
Wall Switch. Pull Switch out from Wall Outlet Box.
Determine the “hot” wire and the “load” wire and
disconnect these wires from existing control
(Figure 26).
Do not attempt to disconnect any wires not already
connected to existing control.
FACEPLATE
WALL
SWITCH
OUTLET
BOX
SCREWS
Figure 26
7. Wall Control Installation
(Continued)
Screw Wall Control into Wall Box using the supplied
screws. Leave Wall Control in “OFF” mode until fan
installation is completed.
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control (Figure 27).
Install Decorator Wall Plate using the two screws
provided with Wall Plate. Leave Wall Control in “OFF”
mode until fan installation is completed (Figure 27).
Skip to Section 7.7 if using a 3-way switch
installation.
SINGLE-POLE INSTALLATION
