2.
Remove the fan motor/housing
assembly from the protective plastic
bag. Place the fan assembly into the
lower foam pad with the bottom of the
motor facing up.
The lower foam pad serves as a holder
for the fan during the first stages of
assembly.
General
Your Emerson ceiling fan comes supplied
with a Fan/Light Remote Control which
consists of a remote control (transmitter)
and a remote control receiver mounted
under the ceiling cover. This system
allows you to regulate your ceiling fan
speed and light intensity.
NOTE: An optional Emerson Electric
SW406 Wall Control may also be used
to control your ceiling fan.
4
U.L. Model No.: CF205
To reduce the risk of fire, electric
shock, or personal injury, mount fan
to outlet box marked “Acceptable for
Fan Support”, and use screws sup-
plied with outlet box. Most outlet
boxes commonly used for support of
light fixtures are not acceptable for
fan support and may need to be
replaced. Consult a qualified electri-
cian if in doubt.
!
WARNING
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned off
at the main fuse box before wiring. All
wiring must be in accordance with
National and Local codes and the ceil-
ing fan must be properly grounded as
a precaution against possible electri-
cal shock.
!
WARNING
To avoid possible fire or shock, fol-
low all wiring instructions carefully.
Any electrical work not described in
these instructions should be done or
approved by a licensed electrician.
!
WARNING
If your fan is to replace an existing ceiling
light fixture, turn electricity off at the main
fuse box at this time and remove the exist-
ing light fixture.
Electrical Requirements
Your new ceiling fan will require a ground-
ed electrical supply line of 120 volts AC,
60 Hz, 15 amp circuit.
The outlet box must be securely anchored
and capable of withstanding a load of at
least 50 pounds.
How to Assemble Your
Ceiling Fan
1.
Mount the fan blades to the blade
flanges using three 10-24 x 9mm oval
head screws and three decorative
blade nuts (supplied) (Figure 4).
FAN BLADE
DECORATIVE
BLADE NUTS (3)
BLADE
FLANGE
10-24 X 9mm OVAL
HEAD SCREW (3)
Figure 4
To reduce the risk of personal injury,
do not bend the blade flange when
installing the blade flanges, balanc-
ing the blades or cleaning the fan. Do
not insert foreign objects in between
rotating fan blades.
!
WARNING
BP7375-1 Highpointe 8/19/10 2:50 PM Page 4