7
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF442
7.
Carefully turn partially assembled fan upside down
and place in styrofoam form carton, in preparation for
final installation.
8.
Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 6). Remove the pin from the
downrod, then remove the hanger ball. Retain the pin
and hanger ball for reinstallation in Step 9.
9.
Separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod. Remove the upper setscrew from the motor
coupling. Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install the clevis
pin and secure with the hairpin clip (Figure 7). The
clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the
downrod to make sure the clevis pin is properly
installed. Reinstall the upper setscrew in the motor
coupling. Check that the lower setscrew is tightened
securely (Figure 7).
NOTE: The setscrews must be properly installed as
described above, or fan wobble could result.
3. Ceiling Fan Assembly
(continued)
HAIRPIN
CLIP
CLEVIS
PIN
UPPER
SETSCREW
CLEVIS
PIN
SETSCREW
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW
CLEVIS PIN
DOWNROD
MOTOR COUPLING
Figure 7
DOWNROD
CEILING
COVER
COUPLING
COVER
Figure 8
It is critical that the clevis pin in the motor coupling is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 6
10.
Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that the
ceiling cover and the coupling cover are both
oriented correctly (Figure 8).
