Instruction Manual
D104170X012
SV Electric Actuator
July 2017
2
Actuator Specifications
Table 1. Baumann Actuator Specifications
ACTUATOR TYPE
SVX24-MFT
SVK24-MFT
POWER FAILURE
Lock in last position
Fail Open / Fail Closed
ACTION
Direct or Reverse
POWER CONSUMPTION
4 W
8.5 W
TRANSFORMER SIZE
6 VA (class 2 power source)
21 VA (class 2 power source)
TRAVEL
12.7 and 19.1 mm (0.50 and 0.75 inches)
MATERIAL
Housing
Aluminum die cast and plastic casing
YOKE Legs
Aluminum
ENCLOSURE RATING
NEMA 2, / IP 54 UL Enclosure Type 2
INPUT SIGNAL
2 - 10 VDC or 4 - 20 mA input signal
POWER SUPPLY
24 VAC or 24 VDC
ELECTRICAL CONNECTION
3 ft, 18GA appliance cable, 0.5 inch conduit fitting
AMBIENT TEMPERATURE
-30 to 50
_
C (-22 to 122
_
F)
RELATIVE HUMIDITY RANGE
5 to 95% RH, non-condensing
OUTPUT THRUST
1500 N (337 lbf)
VALVE STEM POSITION FEEDBACK OUTPUT
2-10 VDC (0.5 mA maximum)
SHUTOFF CLASS
Class IV or VI per ANSI/FCI 70-2 (Refer to Valve Technical Bulletin)
TRAVEL TIME
35 seconds
NOISE LEVEL
< 45 dB(A)
MANUAL OVERRIDE
4 mm Hex Head
POSITION INDICATION
Travel Indicator on Yoke
SPLIT RANGE CAPABILITY
Yes
AGENCY APPROVALS
CE (A), UL 60730-1A/-2 -14, CSA E60730-1:02 (CE approval for actuator only)
QUALITY STANDARD
ISO 9001
WEIGHT
1.3 kg (2.9 lbs)
1.6 kg (3.6 lbs)
WARNING
Always wear protective gloves, clothing and eyewear when performing any installation operations to avoid personal
injury.
Personal injury or property damage caused by sudden release of pressure or bursting of pressure retaining parts may result
if service conditions exceed those for which the product was intended. To avoid injury or damage, provide a relief valve for
over pressure protection as required by government or accepted industry codes and good engineering practices.
Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
If installing into an existing application, also refer to the WARNING at the beginning of the Maintenance section in this
instruction manual.
CAUTION
This actuator is intended for a specific range of pressures, temperatures and other application specifications. Applying
different pressures and temperatures to the actuator could result in parts damage, malfunction of the actuator or loss of
control of the process. Do not expose this product to service conditions or variables other than those for which the product
was intended. If you are not sure what these conditions are you should contact your
Emerson sales office
or Local Business
Partner for more complete specifications. Provide the product serial numbers (shown on the nameplate) and all other
pertinent information.
