Document Part # 026-4280 Rev 1
Page 9 of 33
©2022 Emerson Digital Cold Chain, Inc. This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
8
Fast Access Menu
The Fast Access menu contains the list of probes and values that are automatically emptied by the board such as the superheat
and percentage of valve opening. The values: nP or noP stand for probe not present or value not emptied, and Err means the
value is out of range, the probe is damaged, not connected, or configured incorrectly
.
9
Multimaster Function Menu (SEC)
The function “section” SEC is enabled when the
icon is lit. It allows entering the remote programming mode from a keyboard
not physically connected to the board through the LAN functionality
.
ENTERING THE FAST ACCESS
MENU
Press and release the up arrow key. The duration of the menu in
case of inactivity is about 3 minutes. Depending on the
configuration of the board, the values display.
To select an entry, press the
or
, then press
to view
the value or to move to the next
value.
MAP
Current map (0 to 3): it shows which map is used
HM
Access to clock menu or reset the RTC alarm
An
Value of analog output
dP1
(Pb1) Value read by probe 1
dP2
(Pb2) Value read by probe 2
dP3
(Pb3) Value read by probe 3
dp4
(Pb4) Value read by probe 4
rCP
Value of P4 remote probe for heaters. It is displayed only with P4C = LAn.
If the value is not available “noP” label is displayed.
dPr
Virtual probe for room temperature regulation [
rPA
and
rPb
]
rSE
Real thermoregulation setpoint: the value includes the sum of SET,
HES and/or the dynamic setpoint if the functions are enabled.
L°t
Minimum room temperature
H°t
Maximum room temperature
tMd
Time to next defrost (minutes)
LSn
Number of devices in the LAN
LAn
Address list of devices in the LAN
GAL
To see all the active alarms in each device connected to the LAN
EXIT
Press together or wait the time out for 60 seconds.
Table 8-1 - Fast Access Menu
Figure 9-1 - LAN Connection