SI-I/O User Guide
9
Issue Number: 3
4 Mechanical installation
4.1
General installation
The installation of an Option module is illustrated in Figure 4-1.
Figure 4-1 Installing an Option module
4.1.1 Installing the first Option module
•
Option module slots must be used in the following order: slot 3, slot 2 and slot 1. Orientate the Option module above the drive as shown in (1).
Align and insert the Option module tab into the slot (2). Press down on the Option module until it clicks into place.
Adding Option modules: Populate slot
3
first, then slot
2
and finally slot
1
1
2
1
2
3
